Hp Officejet J5740 All-in-One Printer User Manual download pdf (Page 37)

Figure 4-5 Back view of the HP All-in-One

1 Telephone wall jack

2 Use the phone cord supplied in the box with the HP All-in-One to connect to the "1-LINE" port

To set up the HP All-in-One with voice mail

1. Using the phone cord supplied in the box with the HP All-in-One, connect one end to

your telephone wall jack, then connect the other end to the port labeled 1-LINE on

the back of the HP All-in-One.

NOTE: If you do not use the supplied cord to connect from the telephone wall

jack to the HP All-in-One, you might not be able to fax successfully. This special

phone cord is different from the phone cords you might already have in your home

or office.

2. Turn off the Auto Answer setting.

3. Run a fax test.

You must be available to respond in person to incoming fax calls, or the HP All-in-One

cannot receive faxes.

Case G: Fax line shared with computer dial-up modem (no voice calls received)

If you have a fax line on which you receive no voice calls, and you also have a computer

dial-up modem connected on this line, set up the HP All-in-One as described in this

section.

Since your computer dial-up modem shares the phone line with the HP All-in-One, you

will not be able to use both your modem and the HP All-in-One simultaneously. For

Fax setup 35

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 285 286

No comments

Hp Officejet J5740 All-in-One Printer User Manual Page 37