Hp Officejet J5740 All-in-One Printer User Manual download pdf (Page 182)

Solution: If you did not load an original in the document feeder tray, or if the original

is not pushed in far enough, you will be unable to send a fax manually. Load an original

in the document feeder tray, or push the original farther into the tray. Once the HP All-

in-One detects the original, a confirmation message appears on the display.

Pages of a fax I sent are missing

Cause: Two or more pages were fed through the document feeder tray at the same

time.

Solution: Print a Last Transaction report to verify the number of pages that were

sent. If two or more pages stuck together and were fed into the document feeder tray

at the same time, the number of pages in the report would not match the actual

number of pages. If the number of pages listed in the report does not match the actual

number of pages, you might need to clean the separator pad in the automatic

document feeder.

To print a Last Transaction report

1. Press Setup, and then press 2.

This selects Print Report.

2. Press

to select Last Transaction, and then press OK.

For more information on cleaning the separator pad, see

Clean the automatic

document feeder.

Cause: The receiving fax machine is having problems.

Solution: To check this, try calling the fax number from a telephone and listen for

fax tones. If you cannot hear fax tones, the receiving fax might not be turned on or

connected, or a voice mail service could be interfering with the recipient's phone line.

The memory of the receiving fax machine might be full or the fax machine might have

run out of paper. You can ask the recipient to check the receiving fax machine for any

problems.

Cause: The phone line connection is noisy. Phone lines with poor sound quality

(noise) can cause faxing problems.

Solution: If the failure was due to noise on the phone line, contact the sender to

have them resend the fax. The quality might be better when you try again. You can

check the sound quality of the phone line by plugging a phone into the telephone wall

jack and listening for static or other noise. If the problem persists, turn Error

Correction Mode (ECM) off and contact your telephone company.

To change the ECM setting from the control panel

1. Press Setup.

2. Press 5, and then press 6.

This selects Advanced Fax Setup and then selects Error Correction Mode.

3. Press

to select On or Off.

4. Press OK.

Chapter 12

180 Troubleshooting

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 285 286

Comments to this Manuals

No comments

Hp Officejet J5740 All-in-One Printer User Manual Page 182

Comments to this Manuals

Related products and manuals for Printers Hp Officejet J5740 All-in-One Printer