Hp Officejet J5740 All-in-One Printer User Manual download pdf (Page 166)

Cause: The size of the document you are printing is larger than the paper loaded

in the input tray.

Solution: Make sure the layout of the document you are trying to print fits on a paper

size supported by the HP All-in-One.

To preview the print layout

1. Load the correct paper size into the input tray.

2. Preview your print job before sending it to the HP All-in-One.

3. Check the graphics in the document to make sure that the current size fits within

the printable area of the HP All-in-One.

4. Cancel the print job if the graphics do not fit in the printable area of the page.

TIP: Some software applications allow you to scale the document to fit the paper

size currently selected. Additionally, you can scale the size of a document from

the print Properties dialog box.

Cause: The paper is loaded incorrectly.

Solution: If the paper is misfeeding, it could cause parts of the document to cut off.

Remove the stack of paper from the input tray, and then reload the paper following

the steps below.

To load full-size paper

1. Remove the output tray.

2. Slide the paper-width guide to its outermost position.

Chapter 12

164 Troubleshooting

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 285 286

No comments

Hp Officejet J5740 All-in-One Printer User Manual Page 166