Hp LaserJet 3055 User Manual Page 372

  • Download
  • Add to my manuals
  • Print
  • Page
    / 430
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 371
Network problems
Verifying that the all-in-one is on and online
To verify that the all-in-one is on and online
Check the following items to make sure the all-in-one is ready to print.
1. Is the all-in-one plugged in and turned on?
Make sure that the all-in-one is plugged in and turned on. If the problem persists, you might
have a defective power cable, power source, or all-in-one.
2. Is the all-in-one Ready light on?
If the light is blinking, you might need to wait until the current job is completed.
3. Is the all-in-one control-panel display blank?
Make sure the all-in-one is turned on.
Make sure the all-in-one is installed correctly.
4. Does a message other than Ready appear on the all-in-one control-panel display?
See your all-in-one documentation for a complete list of control panel messages and
corrective actions.
Resolving communication problems with the network
To resolve communication problems with the network
Check the following items to verify that the all-in-one is communicating with the network. This
information assumes you have already printed a Network configuration page (see
Configuration
page).
1. Are there any physical connection problems between the workstation or file server and the all-in-
one?
Verify that the network cabling, connections, and router configurations are correct. Verify that
the network cable lengths meet network specifications.
2. Are your network cables connected properly?
Make sure that the all-in-one is attached to the network using the appropriate port and cable.
Check each cable connection to make sure it is secure and in the right place. If the problem
continues, try a different cable or ports on the hub or transceiver. The amber activity light and
the green link status light next to the port connection on the back of the all-in-one should be lit.
3. Are the link speed and duplex settings set correctly?
Hewlett-Packard recommends leaving this setting in automatic mode (the default setting). See
Link speed and duplex settings.
4. Can you "ping" the all-in-one?
Use the command prompt to ping the all-in-one from your computer. For example:
354 Chapter 13 Troubleshooting ENWW
Page view 371
1 2 ... 367 368 369 370 371 372 373 374 375 376 377 ... 429 430

Comments to this Manuals

No comments