Hp LaserJet 3055 User Manual Page 361

  • Download
  • Add to my manuals
  • Print
  • Page
    / 430
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 360
Problem Cause Solution
that is available determines the actual
number of faxes stored for reprinting.)
As soon as possible, replace the print
cartridge, and then reprint the fax. See
Reprinting a fax.
The fax that was sent was too light. Contact the sender and have the
sender resend the fax after altering the
settings.
Problems sending faxes
Problem Cause Solution
The document stops feeding in the
middle of faxing.
The maximum length of a page that
you can load is 381 mm (15 inches).
Faxing of a longer page stops at 381
mm (15 inches).
Print the document on shorter media.
If no jam exists and less than one
minute has elapsed, wait a moment
before pressing Cancel. If a jam exists,
see
Clearing jams. Then, resend the job.
If the item is too small, it can jam inside
the automatic document feeder (ADF).
Use the flatbed scanner. The minimum
page size for the ADF is 127 x 127 mm
(5 x 5 inches).
If a jam exists, see
Clearing jams.
Then, resend the job.
Faxes stop during sending. The fax machine to which you are
sending might be malfunctioning.
Try sending to another fax machine.
Your telephone line might not be
working.
Do one of the following:
Turn up the volume on the all-in-
one, and then press Start Fax on
the control panel. If you hear a
dial tone, the telephone line is
working.
Disconnect the all-in-one from the
jack in the wall, and then connect
a telephone to the jack. Try to
make a telephone call to verify
that the telephone line is working.
A communication error might be
interrupting the fax job.
Change the redial-on-communication-
error setting to On (see the information
about changing the redial-on-
communication-error option under
Changing the redial settings).
The all-in-one is receiving faxes but is
not sending them.
If your all-in-one is on a PBX system,
the PBX system might be generating a
dial tone that the all-in-one cannot
detect.
Disable the detect-dial-tone setting.
See
Changing the detect-dial-tone
setting.
A poor telephone connection might
exist.
Try again later.
The fax machine to which you are
sending might be malfunctioning.
Try sending to another fax machine.
ENWW Fax problems 343
Page view 360
1 2 ... 356 357 358 359 360 361 362 363 364 365 366 ... 429 430

Comments to this Manuals

No comments