Reducing or enlarging copies
The all-in-one can reduce copies to as little as 25% of the original size or enlarge copies to as much
as 400% of the original size.
Reduction/enlargement settings
●
Original=100%
●
Lgl > Ltr=78%
●
Lgl > A4=83%
●
A4 > Ltr=94%
● Ltr > A4=97%
●
Full Page=91%
●
Fit to page (HP LaserJet 3052/3055/3390/3392 all-in-one only)
●
2 pages/sheet
●
4 pages/sheet
●
Custom: 25-400%
NOTE When using the Fit to page setting, copy from the flatbed scanner only.
When using the 2 pages/sheet or 4 pages/sheet setting, copy from the automatic document
feeder only. Also, after selecting the 2 pages/sheet or 4 pages/sheet option, you must select
the page orientation (portrait or landscape).
Adjusting the copy size
To reduce or enlarge copies for the current job
1. On the all-in-one control panel, press Reduce/Enlarge.
2. Select the size to which you would like to reduce or enlarge the copies in this job.
NOTE If you select Custom: 25-400%, type a percentage by using the alphanumeric
buttons.
If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or
landscape).
3.
Press Start Copy to save the selection and immediately start the copy job, or press
to save
the selection without starting the job.
NOTE The change in the setting remains active for about two minutes after the copy job has
been completed. During this time, Settings=Custom appears on the all-in-one control-panel
display.
You must change the default media size in the media input tray to match the output size, or
part of your copy might be cut off.
124 Chapter 7 Copy ENWW
Comments to this Manuals