HP 1240 Fax series Quick Start Guide download pdf (Page 86)

hp fax 1240 series

chapter 7

fax setup

faxing from a DSL line

If you have a digital subscriber line (DSL) service through your phone company,

use the instructions in this section to connect a DSL filter between the telephone

wall jack and your HP Fax. This filter removes the digital signal that would block

your HP Fax from communicating properly with the telephone line.

Caution! If you have a DSL line and you do not connect the DSL

filter, you will not be able to send and receive faxes with your

HP Fax.

Caution! If you do not use the supplied cord to connect from the

DSL filter to your HP Fax, you may not be able to fax successfully.

If you live in one of the countries listed in the table on page 77,

you received a special 2-wire cord. This special 2-wire cord is

different from the more common 4-wire phone cords you might

already have in your office. For more information about how to

tell the difference between the cords, see I have difficulties when

sending faxes and when receiving faxes. on page 105.

1 Obtain a DSL filter from your DSL provider.

2 Using the phone cord supplied in the box with your HP Fax, connect one

end to the open port on the DSL filter, then connect the other end to the

port labeled “1-LINE” on the back of your HP Fax.

3 Connect the DSL filter cord to the telephone wall jack.

4 Proceed to how to tell if the following instructions apply to you on

page 77 to determine what else you need to do to finish setting up your

HP Fax.

Telephone

wall jack

Back view of the

Use t

e p

one cor

supp

the box with your HP Fax

DSL filter

supplied by your

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 147 148

No comments

HP 1240 Fax series Quick Start Guide Page 86