HP D5300 User Manual download pdf (Page 101)

NOTE: To avoid paper jams, tuck the flaps inside the envelopes.

For more information, see:

“

Load envelopes” on page 21

Text or graphics are cut off at the edge of the page

Cause: The margins are not set correctly in your software application.

Solution:

To check your margin settings

1. Preview your print job before sending it to the HP Photosmart.

2. Check the margins.

The HP Photosmart uses the margins you have set in your software application,

as long as they are greater than the minimum margins the HP Photosmart

supports.

3. Cancel the print job if the margins are not satisfactory, and then adjust the margins

in your software application.

Make sure the margin settings for the document do not exceed the printable area of

the HP Photosmart.

Cause: The size of the document you are printing is larger than the paper loaded

in the input tray.

Solution: Make sure the layout of the document you are trying to print fits on a paper

size supported by the HP Photosmart.

To preview the print layout

1. Load the correct paper size into the input tray.

2. Preview your print job before sending it to the HP Photosmart.

3. Check the graphics in the document to make sure that the current size fits within

the printable area of the HP Photosmart.

4. Cancel the print job if the graphics do not fit in the printable area of the page.

Chapter 11

100 Troubleshooting

Troubleshooting

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 148 149

No comments

HP D5300 User Manual Page 101