![](/jointfilesconvert/508577/bg32.png)
4. Push the green release lever on the right rear side of the drive toward the center of the drive (1), and
then slide the drive forward and out of the bay (2).
Installing a 9.5 mm slim optical drive
1. Prepare the computer for disassembly (Preparation for disassembly on page 18)
2. Remove the access panel (Access panel on page 19)
3. Remove the front bezel (Front bezel on page 20). If you are installing a drive in a bay covered by a bezel
blank, remove the bezel blank. See Removing bezel blanks on page 22 for more information.
4. Align the small pin on the release latch with the small hole on the side of the drive and press the latch
rmly onto the drive.
40 Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
Comments to this Manuals