HP rp2450 Manual download pdf (Page 86)

Chapter

Server Slide Rail Installation

Do not lift or carry the server by the bezel. The bezel is made of plastic and

is attached to the server chassis by two bezel retainers and four ball-posts.

It will only support the weight of the server chassis in an emergency.

Failure to heed this warning may result in personal injury and/or

permanent damage to the server

NOTE The rail sets on both sides of the chassis must be properly aligned and engaged

before attempting to slide the server into the cabinet.

The inner rail (attached to the server) must have both top and bottom edges inside

the outer (cabinet) rails

Step 10. Carefully guide the inner slide rails on the server chassis into the outer rails, engaging the ball

bearing carriers.

CAUTION Do NOT force the slides together. To do so may damage the ball bearing carriers. The

inner slides will latch after travelling a few inches.

Step 11. Press the slide latches on the inner slides and carefully slide the server completely into the rack.

Step 12. Verify operation of the slides and check alignment of the server in the rack.

ccrr014

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 201 202

No comments

HP rp2450 Manual Page 86