HP rp2450 Manual Page 183

  • Download
  • Add to my manuals
  • Print
  • Page
    / 202
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 182
Chapter
PCI Backplane Removal
255
PCI Backplane Removal
The PCI backplane is located on the back of the I/O Card cage. I/O slot 1 is located on the outside of the PCI
I/O card cage and slots 2, 3, and 4 are attached to the PCI backplane inside the I/O card cage.
CAUTION Ensure that the system is shut down and power removed from the server before attempting
removal or replacement of a component.
To remove the PCI backplane from the server, perform the following steps:
Step 1. Remove the I/O cables from the back of the server.
Step 2. Remove the I/O card from slot 1.
Step 3. Remove the I/O card cage from the server.
CAUTION Do not scrape the I/O Backplane against the CPU heat sink when removing or
replacing the card cage. Failure to heed this precaution could cause serious damage
to the backplane and require replacement.
Step 4. Remove all PCI cards.
NOTE Note the order of PCI card installation prior to removal. Cards must be re-installed
in the same slots, or I/O reconfiguration may be required.
Step 5. Lay the I/O card cage, open side down, on a clean, dry surface. The PCI backplane is facing up.
Step 6. Remove the T-10 retainer screw from the PCI backplane.
Step 7. Slide the PCI backplane to one side, so that the retainer posts will clear the keyhole slots.
Step 8. Grasp the PCI backplane by the edges and carefully remove it from the card cage.
The following photograph shows the PCI Backplane.
Page view 182
1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 201 202

Comments to this Manuals

No comments