HP rp2450 Manual Page 201

  • Download
  • Add to my manuals
  • Print
  • Page
    / 202
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 200
Chapter
Insert the Server into the Rack
297
Insert the Server into the Rack
rp24xx servers are available in three configurations: rack-mounted, stacked, or stand-alone. Access to servers
mounted in an HP-supported rack is covered in this section.
To return the server into the rack, perform the following steps:
Step 1. Push and hold each rail clip in to unlock the rail from the fully extended position. Slowly push
server chassis completely into the rack.
Step 2. Replace the four T-25 screws on each side of the server that fasten it to the rack.
Step 3. Attach the front Bezel.
The following graphic shows the server extended and indicates the rail clip location.
ccrr014
Page view 200
1 2 ... 196 197 198 199 200 201 202

Comments to this Manuals

No comments