SROS Command Line Interface Reference Guide HDLC Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 843
lldp send [management-address l port-description l
system-capabilities l system-description l system-name l
and-receive]
Use the lldp send command to configure this interface to transmit LLDP packets or to control the types of
information contained in the LLDP packets transmitted by this interface.
Syntax Description
management-address Enables transmission of management address information on this interface.
port-description Enables transmission of port description information on this interface.
system-capabilities Enables transmission of this device’s system capabilities on this interface.
system-description Enables transmission of this device’s system description on this interface.
system-name Enables transmission of this device’s system name on this interface.
and-receive Configures this interface to both transmit and receive LLDP packets.
Default Values
Be default, all interfaces are configured to transmit and receive LLDP packets of all types.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual
HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel
interfaces (tunnel 1), and VLAN interface (vlan 1).
Functional Notes
Individual LLDP information can be enabled or disabled using the various forms of the lldp send
command. For example, use the lldp send and-receive command to enable transmit and receive of all
LLDP information. Then use the no lldp send port-description command to prevent LLDP from
transmitting port description information.
Usage Examples
The following example configures the HDLC interface to transmit LLDP packets containing all enabled
information types:
(config)#interface hdlc 1
(config-hdlc 1)#lldp send
The following example configures the HDLC to transmit and receive LLDP packets containing all
information types:
(config)#interface hdlc 1
(config-hdlc 1)#lldp send and-receive
Comments to this Manuals