Hp Officejet J5740 All-in-One Printer User Manual download pdf (Page 230)

connected to the port labeled 1-LINE on the back of your HP All-in-One and the

other end to your telephone wall jack, as shown below.

1 Telephone wall jack

2 Phone cord supplied in the box with the HP All-in-One

• Check the connection between the telephone wall jack and the HP All-in-One to

make sure the phone cord is secure.

Cause: The "Fax Line Condition" test failed.

Solution:

What to do

• Make sure you connect the HP All-in-One to an analog phone line or you will not

be able to send or receive faxes. To check if your phone line is digital, connect a

regular analog phone to the line and listen for a dial tone. If you do not hear a

normal sounding dial tone, it might be a phone line set up for digital phones.

Connect the HP All-in-One to an analog phone line and try sending or receiving

a fax.

• Check the connection between the telephone wall jack and the HP All-in-One to

make sure the phone cord is secure.

• Make sure you have correctly connected the HP All-in-One to the telephone wall

jack. Using the phone cord supplied in the box with the HP All-in-One, connect

one end to your telephone wall jack, then connect the other end to the port labeled

1-LINE on the back of the HP All-in-One. For more information, see

Set up the

HP All-in-One for faxing.

• Other equipment, which uses the same phone line as the HP All-in-One, might

be causing the test to fail. To find out if other equipment is causing a problem,

Chapter 11

228 Troubleshooting

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 295 296

No comments

Hp Officejet J5740 All-in-One Printer User Manual Page 230