HP 72SI User Manual download pdf (Page 89)

Edge-to-Edge Printing 3-41

◆ If the printer reports that the media is skewed, but you can-

not correct the skew, the sheet may not be perfectly square

(90-degree corners with parallel sides). In this case, ensure

that the right edge of the media (closest to the control

panel) is parallel to the direction of media feed. (You can use

the fence on the input (rear) table as a guide after squaring

it to the platen.) Then use the procedures described previ-

ously to ensure enough overprinting to account for the

shape of the sheet. If insufficient overprinting occurs, the

sheet may need to be trimmed for a bleed effect.

Example Document Design

◆ Media size: 48x96 inches (4x8 feet)

◆ Bleeds: Full bleed

◆ Document size in application software: 48.5 inches x 96.0

inches, to include an overprint of 0.25 inches on the left and

right edges (the printer will not overprint the leading edge,

to avoid feeding the media over wet ink on the platen)

Media Properties

◆ The operator selects a flat sheet of 4x8-foot media with

opposite sides parallel and all four corners at 90 degree

angles.

◆ The operator attaches a trailer that is 6.5 inches (16.5 cm)

long and 48 inches wide to the trailing edge of the media,

applying the adhesive tape to the back side.

Fig. 3-22. Feeding a non-square sheet

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 167 168

No comments

HP 72SI User Manual Page 89