HP 72SI User Manual download pdf (Page 58)

3-10 Loading Ink

Loading Ink

When to Load Ink The amount of ink in the ink box is tracked by the printer soft-

ware and recorded on its corresponding profiler. When the ink

box is almost empty, the LED above the corresponding profiler

will blink. You should replace the ink box with a full ink box of

the same color ink as soon as possible. The status of each ink

box and profiler is indicated by the LEDs as follows:

◆ Off — OK

◆ Slow Blink — profiler is being verified after insertion

◆ Fast Blink — low ink warning (300 ml remaining)

◆ On — ink system action (ink empty, ink pump failure, pro-

filer error, or other), see control panel

Unloading an Empty Ink

Box

1. Remove the profiler.

2. Lift the box out of its holder and turn the box upside down so

the ink tube is pointing up.

3. Lift the retaining clip on the ink tube connector and disen-

gage the tube from the ink box.

4. Remove and dispose of the ink box (refer to the MSDS for

proper disposal procedures).

Loading a Full Ink Box 1. Open the new ink box and locate the supply connector.

Fig. 3-2. Ink box with supply connector

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 167 168

No comments

HP 72SI User Manual Page 58