HP 72SI User Manual download pdf (Page 73)

Unloading and Cutting Roll-Fed Media 3-25

Unloading and

Cutting Roll-Fed

Media

1. Press the ) key on the Front Page screen to advance the

printed portion of the media past the postheater.

2. On the Front Page screen of the control panel, press the

Unload key.

3. The control panel prompts you to press ! to unload media,

or ( to cancel.

4. Press ! to continue.

This detensions the supply and takeup spools.

5. Cut through the media with a utility knife along the cutting

channel in the platen or below the postheater.

As you cut the media from the printer, hold it to prevent it

from falling to the floor and possibly damaging it.

Note

If you scratch the platen while cutting media, be sure

to buff them out with a fine grade of sandpaper.

Scratches in the platen can cause media feed incon-

sistencies, which can lead to head strikes and arti-

facts in printed output.

6. Take the single print or the entire takeup spool with printed

output to your finishing area, and re-load the takeup system.

◆ To re-load the takeup, from the menu, press the Load

key on the control panel.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 167 168

No comments

HP 72SI User Manual Page 73