Hardware options installation 42
7.
Connect the optical drive and power cable to the 9.5-mm optical drive.
8. Route the cable and connect the cable's SATA connector to the system board.
9. Connect the cable's power connector to the power supply.
10. Install the secondary access panel.
11. Install the primary access panel.
12. Install the server into the rack.
Expansion board option
To install the component:
1. Power down the server (on page 20).
2. Remove the server from the rack (on page 20).
3. Remove the primary access panel (on page 21).
Comments to this Manuals