HP 132A User Manual download pdf (Page 33)

Chapter 2 Command Summary

Front Panel to SCPI Command Maps

Programming Guide 2-9

MEASURE Keys to SCPI Command Map (Cont.)

1 a. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]FREQuency [1 | 2 | 3] ”

b. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]FREQuency:RATio

[1,2 | 1,3 | 2,1 | 3,1] ”

2 a. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]TOTalize [1] ”

b. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]PHASe [1,2] ”

c. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]DCYCle [1] ”

d. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLTage:MINimum [1] ”

[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLTage:MAXimum [1] ”

e. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLTage:MINimum 2 ”

[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLTage:MAXimum 2 ”

3 a. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]TINTerval [1,2] ”

b. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]PERiod [1] ”

c. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]RISE:TIME [1] ”

d. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]FALL:TIME [1] ”

e. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]PWIDth [1]”

f. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]NWIDth [1]”

Since the primary purpose of these front-panel keys is to change the function, the

corresponding [:SENSe]:FUNCtion[:ON] command is listed in the menu map

above. The front-panel keys, however, invoke couplings which affect other

settings, whereas the [:SENSe]:FUNCtion[:ON] command does not.

Figure 2-3. MEASURE Keys to SCPI Command Map (Part 2 of 2)

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 329 330

No comments

HP 132A User Manual Page 33