HP 132A User Manual download pdf (Page 213)

Chapter 4 Command Reference

Introduction

Programming Guide 4-47

• When :TRIG:COUN:AUTO is ON and :CAL3:AVER[:STAT] is ON, the

Counter clears the statistics results and the statistics current count on

:INIT[:IMM].

• If the instrument is already in the process of making a measurement or if

INITiate:CONTinuous is set to ON, an :IMMediate command has no affect,

and an error -213

(Init ignored) is generated.

• When :CALC2:LIM:CLE:AUTO is ON, the Counter performs the following

whenever the :INIT[:IMM] command is sent:

– invalidates the limit data,

– clears :CALC2:LIM:FAIL, :CALC2:LIM:FCOunt, and

:CALC2:LIM:PCOunt information,

– turns off the front-panel display’s Limit annunciator, and

– sets the Limit-Detect output to the in-limit voltage level.

• This command is an overlapped command (see IEEE 488.2, Section 12).

Beginning a measurement or block of measurements with an

:INITiate[:IMMediate] sets the Pending Operation Flag to true. Completing

the measurement or block of measurements (normally or by aborting) sets

Pending Operation Flag to false.

• For an automatically armed Totalize measurement, use :ABORt to terminate

the measurement initiated with :INIT[:IMM].

• When [:SENS]:EVEN:LEV[:ABS]:AUTO is ON, the Counter performs an

auto-trigger on the measurement channel(s) whenever the :INIT[:IMM]

command is executed.

Stop/Single

Comments

Front-Panel

Keys

1 2 ... 208 209 210 211 212 213 214 215 216 217 218 ... 329 330

No comments

HP 132A User Manual Page 213