HP 132A User Manual download pdf (Page 273)

Chapter 4 Command Reference

Introduction

Programming Guide 4-107

:STATus Subsystem

The :STATus subsystem commands allow you to specify or examine the status of

the Operation Status Register group and the Questionable Data/Signal Register

group.

:STATus:OPERation Subtree

The :STATus:OPERation subtree commands allow you to examine the status of

the Counter monitored by the Operation Status Register group, shown in Figure 4-

2. The Operation Status Register group consists of a condition register, two

transition registers, an event register, and an enable register. The commands in this

subtree allow you to control and monitor these registers.

See the section titled “Operation Status Register Group and Questionable

Data/Signal Status Register Group” on page 3- 32 in Chapter 3 for a detailed

description of the Operation Status Register Group.

Figure 4-2. The Operation Status Register Group

:STATus:OPERation:CONDition?

Queries the status of the Operation Condition Status Register.

Bits are not cleared when read.

• Numeric data transferred as ASCII bytes in <NR1> format.

• Range is 0 to 65,535.

• The query response value is an integer formed by the

binary-weighting of the bits. The value of unused bits is zero.

The Operation Condition Status Register is cleared at power-on.

Query Response

Comments

1 2 ... 268 269 270 271 272 273 274 275 276 277 278 ... 329 330

No comments

HP 132A User Manual Page 273