HP 132A User Manual download pdf (Page 211)

Chapter 4 Command Reference

Introduction

Programming Guide 4-45

• *RST: OFF

• When the :INIT:CONT ON command is sent, the Counter:

– invalidates the statistics results,

– clears the statistics current count to 0,

– reports the negative status condition (NOT Computing

Statistics) to bit 8 of Operation Status Register.

• When :CALC2:LIM:CLE:AUTO is ON, the Counter performs the following

whenever the :INIT:CONT ON command is sent:

– invalidates the limit data,

– clears :CALC2:LIM:FAIL, :CALC2:LIM:FCOunt,

and :CALC2:LIM:PCOunt information,

– turns off the front-panel display’s Limit annunciator, and

– sets the Limit-Detect output to the in-limit voltage level.

• When [:SENS]:EVEN:LEV[:ABS]:AUTO is ON, the Counter performs an auto-

trigger on the measurement channel(s) whenever the :INIT:CONT ON command

is executed, and also at the beginning of each measurement cycle while

:INIT:CONT is ON.

• The state of :TRIG:COUN:AUTO has no affect on the operation of

:INIT:CONT ON.

• :INIT:CONT ON operates as if :TRIG:COUN was 1.

• The commencement of the first measurement due to setting

:INITiate:CONTinuous to ON sets the Pending Operation Flag to true. The

Pending Operation Flag is set false by aborting of a measurement, or by the

completion of the last measurement after :INITiate:CONTinuous is set OFF.

• With the measurements being made continuously, the :ABORt command shall

abort the current measurement in progress, however, the value of

:INITiate:CONTinuous is unaffected.

If CONTinuous was set to ON prior to receiving :ABORt, it remains ON and

a new measurement begins.

Comments

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 329 330

No comments

HP 132A User Manual Page 211