Hp Designjet T1300 ePrinter User Manual download pdf (Page 50)

NOTE: The first three steps below are optional: you can start with step 4. However, in this case the

printer will not keep track of the length of the roll, and will print no barcode on the roll when it is next

unloaded. So you are recommended to follow all the steps, starting with step 1, unless you have turned

off the Printing paper info option. See

Printing paper info on page 47.

From the front panel, press

, then the roll icon, then Load.

Alternatively, press

, then , then Paper > Paper load > Load roll 1 or Load roll 2.

If the roll you have selected is already loaded, you have to wait while it is automatically unloaded.

You should stand behind the printer when loading the lower roll (roll 2). You may stand behind or

in front of the printer when loading the upper roll (roll 1).

CAUTION: If your height is less than 1.6 m (5 ft 3 in), loading a roll while standing in front of

the printer may cause back pain or other physical problems.

2. In the T1300 series only, if you start to load roll 1 while roll 2 is already loaded, roll 2 is

withdrawn to the standby position, so that it can be printed on again without reloading whenever

required.

NOTE: If at any time you open a roll cover while that roll is in the standby position, the roll will

be automatically unloaded, and you will have to reload it the next time you want to print on it.

3. Open the roll cover, if it is not already open.

4. Rest the spindle's black end on the left side roll holder. Do not put the end completely into the roll

holder.

5. Rest the blue end of the spindle on the right side roll holder.

6. With both hands, push the spindle into both roll holders at the same time.

42 Chapter 5 Paper handling ENWW

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 223 224

No comments

Hp Designjet T1300 ePrinter User Manual Page 50