Hp Designjet T1300 ePrinter User Manual download pdf (Page 57)

NOTE: If the cutter is turned off, it will not cut the paper between jobs, but it will continue to cut the

paper on loading, unloading and switching between rolls.

TIP: To cut roll paper while the automatic cutter is disabled, see Feed and cut the paper

on page 49.

Feed and cut the paper

If you go to the front panel and press , then , then Paper > Form feed and cut, the

printer advances the paper and makes a straight cut across the front edge. There are several possible

reasons why you might want to do this.

●

To trim the leading edge of the paper if it is damaged or not straight.

●

To feed and cut the paper when the automatic cutter has been disabled.

●

To cancel the waiting time and print the available pages immediately, if the printer is waiting to

nest more pages (T1300 series only).

NOTE: The printheads are serviced after each print, and the paper cannot be cut until the process

completes, so you may notice a delay.

CAUTION: Remove the cut piece from the output tray. If strips or short prints are left in the output tray

the printer could jam.

NOTE: Photo and coated paper requires careful handling, see The print is scuffed or scratched

on page 172.

TIP: To move the paper without cutting it, see Move the paper on page 47.

ENWW

Feed and cut the paper

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 223 224

No comments

Hp Designjet T1300 ePrinter User Manual Page 57