Hp Designjet T1300 ePrinter User Manual download pdf (Page 53)

Load a single sheet

1. When using a T1300 series printer, ensure that the cover of roll 1 is closed. If it is opened while a

sheet is loaded, the sheet will be immediately unloaded.

At the front panel, press

then the roll 1 icon, then Load > Load sheet.

Alternatively, press

, then , then Paper > Paper load > Load sheet.

3. If a roll is already loaded, you have to wait while it is automatically unloaded. In the T1300 series

only, the roll is not unloaded, but withdrawn to the standby position, so that it can be printed on

again without reloading as soon as the sheet paper has been unloaded.

NOTE: If at any time you open a roll cover while that roll is in the standby position, the roll will

be automatically unloaded, and you will have to reload it the next time you want to print on it

(T1300 series only).

4. Select your paper category and type.

TIP: If you have loaded a paper type whose name does not appear in the paper list, see The

paper type is not in the driver on page 154.

5. When prompted by the front panel, insert the sheet into the cut-sheet slot on the right side of the

printer.

Load your sheet aligned with the load line and insert until the paper will not continue; with thicker

sheets, you feel resistance.

WARNING! Do not push your fingers inside the printer's paper path.

6. Press the OK key on the front panel to feed the paper into the printer. Guide the sheet into the

printer; this is especially important with thicker papers.

ENWW

Load a single sheet

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 223 224

No comments

Hp Designjet T1300 ePrinter User Manual Page 53