HP EliteDesk 800 65W G3 Desktop Mini PC User Manual download pdf (Page 35)

Replacing SODIMMs

CAUTION: You must disconnect the power cord and wait approximately 30 seconds for the power to drain

before adding or removing memory modules. Regardless of the power-on state, voltage is always supplied to

the memory modules as long as the computer is plugged into an active AC outlet. Adding or removing

memory modules while voltage is present may cause irreparable damage to the memory modules or system

board.

The memory module sockets have gold-plated metal contacts. When upgrading the memory, it is important

to use memory modules with gold-plated metal contacts to prevent corrosion and/or oxidation resulting from

having incompatible metals in contact with each other.

Static electricity can damage the electronic components of the computer or optional cards. Before beginning

these procedures, ensure that you are discharged of static electricity by

briey touching a grounded metal

object.

When handling a memory module, be careful not to touch any of the contacts. Doing so may damage the

module.

1. Prepare the computer for disassembly (Preparation for disassembly on page 20).

2. Remove the top cover (Top cover on page 21).

3. Tilt the fan up using the front tab and leave it in the up position.

NOTE: It is not necessary to fully remove the fan to remove or install a memory module.

4. To remove a memory module, press outward on the latches (1) on each side of the memory module, and

then pull the memory module (2) out of the slot.

Memory 27

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 138 139

No comments

HP EliteDesk 800 65W G3 Desktop Mini PC User Manual Page 35