Hp ProLiant DL585 Server User Manual download pdf (Page 170)

Troubleshooting

H-12 HP ProLiant DL585 Server User Guide

Table H-6: Is the monitor displaying information?

Answer Possible reasons Possible solutions

No The monitor might not

have power.

Video might not be

connected properly.

NVRAM might be

corrupted.

The system ROM and

redundant ROM may be

corrupted.

Be sure that the monitor AC power cord is plugged in

and that the monitor power button has been pressed.

If a video card is installed, be sure that the video cable

is properly connected.

Verify the video connections. Refer to the HP Servers

Troubleshooting Guide.

Clear NVRAM. Refer to the Caution following the

table. Refer to Appendix E for the correct switch

setting.

Are there any audible indicators, such as a series of

beeps? A series of beeps is the audible signal

indicating the presence of a POST error message.

Refer to the HP Servers Troubleshooting Guide for a

complete description of each beep sequence and the

corresponding error messages.

If these steps do not solve the problem, contact an

authorized service provider for assistance.

Yes Video is available for diagnosis. Determine the next

action by observing POST progress and error

messages. Refer to the HP Servers Troubleshooting

Guide for a complete description of each POST error

message.

CAUTION: Clearing NVRAM deletes your configuration information. Refer to the

server maintenance and service guide for complete instructions before performing

this operation or data loss could occur.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 182 183

No comments

Hp ProLiant DL585 Server User Manual Page 170