Hp ProLiant DL585 Server User Manual download pdf (Page 22)

Server operations

HP ProLiant DL585 Server User Guide 2-7

Removing the access panel

WARNING: Pressing the Power on/Standby button sets the server to the

standby position, which removes power from most areas of the server.

However, portions of the power supply and some internal circuitry remain

active until the AC power cord is removed.

WARNING: To reduce the risk of personal injury from hot surfaces, allow the

internal system components to cool before touching.

CAUTION: Electrostatic discharge can damage electronic components. Properly

ground yourself before beginning any installation procedure.

1. Power down the server. Refer to the “Powering down the server” section in this

chapter.

2. Extend the server from the rack. Refer to the “Extending the server from the

rack” section in this chapter.

3. Unlock the access panel latch.

4. Lift up on the latch, and remove the access panel.

Figure 2-6: Removing the access panel

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 182 183

No comments

Hp ProLiant DL585 Server User Manual Page 22