Hp LaserJet 3150 All-in-One Printer series User Manual Page 177

  • Download
  • Add to my manuals
  • Print
  • Page
    / 286
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 176
EN
Resolving control panel error messages 175
Remote Fax was
Busy
The fax number dialed was busy. Try calling later.
Scan Reference
Error
There was an error detected in the
HP LaserJet 3150 product.
Recalibrate the scanner. See
Recalibrating the scanner on
page 215.
Scanner Error #1 An error has occurred in the SRAM. Press and hold S
TOP
/C
LEAR
for seven
seconds to reset the product.
Unplug the power cord from its power
source, wait 10 seconds, and then
replug in the power cord.
Try plugging the product into a different
power source.
If the error persists, service is required.
See the front of this manual for support
information.
Scanner isnt
Available
The scanner mechanism is in use. Wait until the scanner has finished the
current job before sending the next job.
Scanner Jam -
Reload
A document has jammed in the scanner
area.
Pull open the document release door
and then remove the jammed document.
See Selecting items for faxing, copying,
and scanning on page 16 for more
information about preparing documents.
Speed Dial (number)
is not Assigned
You tried to dial a speed-dial code that
does not have a fax number stored in it or
to assign a non-defined one-touch key to
a group.
Choose a speed-dial code to which you
have already assigned a fax number. To
check which speed-dial codes are
assigned, see Printing a one-touch,
speed-dial, and group-dial report on
page 146.
System Error An error has occurred that may require
servicing.
Unplug the power cord from its power
source, wait 10 seconds, and then
replug in the power cord.
Try plugging the product into a different
power source.
If the error persists, service is required.
See the front of this manual for support
information.
Message Cause Solution
Page view 176
1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 285 286

Comments to this Manuals

No comments