Hp 2700 User Manual Page 41

  • Download
  • Add to my manuals
  • Print
  • Page
    / 182
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 40
4. Use the < or the > button to select Manual, and then press OK.
5. Press the > button to increase the value for the first section of the IP address. Press the < button
to decrease the value. When the value is correct, press OK to accept the value and move the cursor
to the next field.
6. If the address is correct, use the < or the > button to select Yes, and then press OK. Repeat step
5 for the subnet mask and default gateway settings.
-or-
If the IP address is incorrect, use the < or the > button to select No, and then press OK. Repeat
step 5 to establish the correct IP address, and then repeat step 5 for the subnet mask and default
gateway settings.
Automatic configuration
1. On the control panel menu, press OK.
2. Use the < or the > button to select Network Config., and then press OK.
3. Use the < or the > button to select TCP/IP config, and then press OK.
4. Use the < or the > button to select Automatic, and then press OK.
It might take several minutes before the automatic IP address is ready for use.
NOTE If you want to disable or enable specific automatic IP modes (such as BOOTP, DHCP,
or AutoIP), these settings can be changed by using the embedded Web server or the
HP ToolboxFX only.
Link speed and link duplex settings
NOTE Incorrect changes to the link speed and link duplex settings might prevent the printer
from communicating with other network devices. For most situations, use the Automatic mode.
Making changes causes the printer to restart. Make changes only while the printer is idle.
1. On the control panel menu, press OK.
2. Use the < or the > button to select Network Config., and then press OK.
3. Use the < or the > button to select Link Speed, and then press OK.
4. Use the < or the > button to select one of the following settings.
10T Full
10T Half
100TX Full
100TX Half
NOTE The printer setting must be the same as the setting for the network device to which
you are connecting (a network hub, switch, gateway, router, or computer).
5. Press OK. The printer restarts.
ENWW Network configuration (HP Color LaserJet 2700n only) 31
Page view 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 181 182

Comments to this Manuals

No comments