HP 2540 Docking StationUser Guide
2. Lift up the computer (2).6 Chapter 2 Docking and undocking
3 Using the docking stationTurning the computer on and offWhen you connect a computer to the docking station, you can turn the computer on and off usi
4. Turn the key to the 1 or 2 position (3) to secure the lock and security cable, and then remove thekey (4).To connect an optional security cable to
4 TroubleshootingIf you experience problems with your docking station, follow the troubleshooting steps below:1. Refer to the information in this chap
External device problems and solutionsProblem Possible Cause SolutionA new device is not recognized as part ofthe system.The computer may not be fully
ASpare partsDescription Part numberSPS-DOCKING STATION 2540 SERIES 598774-00111
B Connector pin assignmentsAudio-out (headphone)Pin Signal1 Audio out, left channel2 Audio out, right channel3 GroundAudio-in (microphone)Pin Signal1
External monitorPin Signal1 Red analog2 Green analog3 Blue analog4 Not connected5 Ground6 Ground analog7 Ground analog8 Ground analog9 +5 VDC10 Ground
RJ-11 (modem)Pin Signal1 Unused2 Tip3 Ring4 Unused5 Unused6 UnusedRJ-45 (network)Pin Signal1 Transmit +2 Transmit -3 Receive +4 Unused5 Unused6 Receiv
Universal Serial BusPin Signal1 +5 VDC2 Data -3 Data +4 GroundUniversal Serial Bus 15
© Copyright 2010 Hewlett-PackardDevelopment Company, L.P.Microsoft is a U.S. registered trademark ofMicrosoft Corporation.The information contained he
C Power cord set requirementsThe wide range input feature of the docking station permits it to operate from any line voltage from 100to 120 volts AC o
Country/region Accredited agency Applicable note numberSweden SEMKO 1Switzerland SEV 1Taiwan BSMI 4The United Kingdom BSI 1The United States UL 21. Th
IndexAAC adapter, connecting 4additional information 3audio-in jackpin assignments 12audio-out jackpin assignments 12Bbuttonsconnect 1, 2, 5power 1,
Table of contents1 Identifying components ...
1 Identifying componentsTop components Component Description(1) Docking posts (2) Align and secure the computer for proper connection to thedocking s
Right-side components Component Description(1) Connect button Secures and releases the computer●Slide in to secure the computer.●Slide out to release
Rear components Component Description(1) Integrated security cable slot (forlocking the docking stationonly)Supports an optional security cable, whic
2 Docking and undockingConnecting to the AC adapterThe docking station requires AC power for full functionality of all ports.WARNING! To reduce the ri
2. Align the docking posts on the docking station with the receptors on the bottom of the computerand lower the computer into the docking station (2).
Comments to this Manuals