5-30 Removal and Replacement Procedures
11. Remove the two screws from the back of the computer that secures the system board
to the base enclosure
➊ (Figure 5-28).
12. Remove the silver screw from the heat sink ➋.
13. Remove the black screws from around the fan ➌, around the USB port ➌, and
around the battery cable in the upper left of the board
➌.
14. Lift up the rear edge of the system board.
15. Remove the system board.
Figure 5-28. Removing the System Board
Reverse the above procedure when installing the system board. Make sure to replace all
components of the base enclosure into their appropriate locations.
Comments to this Manuals