Removal and Replacement Procedures 5-25
5.16 Voltage Converter Board
NOTE: When removing the voltage converter board from the system board, be careful of
the connectors on the right side of the voltage converter board.
1. Prepare the computer for disassembly (Section 5.5).
2. Remove the keyboard (Section 5.11).
3. Remove the switch cover (Section 5.13).
4. Remove the display assembly (Section 5.14).
5. Remove the top cover (Section 5.15).
6. Remove the two screws ➊ that secure the voltage converter board to the system
board (Figure 5-23).
7. Lift up the left side of the voltage converter ➋ until it clears the left edge of the base
assembly.
8. Pull the voltage converter board to the left to disconnect it from the system board ➌.
Figure 5-23. Removing the Voltage Converter Board
Reverse the above procedure to install the voltage converter board. Make sure to attach
the connectors on the right side of the board to the system board first.
Comments to this Manuals