HP Armada m300 Specifications Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 102
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
2-2
Troubleshooting
2.1 Preliminary Steps
IMPORTANT:
Use AC power when running POST or Computer Setup. A low battery
condition could initiate Hibernation and interrupt the test.
Before running POST, complete the following steps:
1. Obtain established passwords. If you must clear the passwords, go to Section 2.2.
2. Ensure that the battery pack is installed and the power cord is connected to the
computer and plugged into an AC power source.
3. Turn on the computer.
4. If a power-on password has been established, type the password and press
Enter.
5. Run Computer Setup (Section 2.5). If a Setup password has been established, type
the password and press
Enter.
6. Turn off the computer and all external devices.
7. Disconnect external devices that you do not want to test. If you want to use the
printer to log error messages, leave it connected to the computer.
NOTE:
If a problem only occurs when an external device is connected to the computer,
the problem could be with the external device or its cable. Isolate the problem by
running POST with and without the external device connected.
8. Use Compaq Utilities and loopback plugs in the serial and parallel connectors if you
plan to test these ports.
Follow these steps to run Compaq Utilities:
a. If you are running Compaq Utilities from the hard drive, turn on or restart the
computer. Press
F10
when the cursor appears in the upper-right corner of the
screen. If you do not press
F10
in time, restart the computer and try again.
If you are running Compaq Utilities from diskette, insert the Compaq Utilities
diskette in drive A. Turn on or restart the computer.
b. Press
Enter
to accept
OK
.
c. Select Prompted Diagnostics.
d. After “Identifying System Hardware” completes, select Interactive Testing and
follow the instructions on the screen.
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 101 102

Comments to this Manuals

No comments