5-22 Removal and Replacement Procedures
5.14 Display Assembly
1. Prepare the computer for disassembly (Section 5.5).
2. Remove the keyboard (Section 5.11).
3. Remove the switch cover (Section 5.13).
4. Use the connector removal tool to disconnect the inverter cable ➊ from the system
board (Figure 5-20)
.
5. Use the connector removal tool to disconnect the microphone cable ➋ and the video
cable
➋ from the system board.
6. Remove display screw covers from the hinges connecting the display assembly to the
base assembly.
7. Remove the four screws (two on each hinge) ➌ that secure the display assembly to
the base assembly.
NOTE: When these four screws are removed, the display assembly is unsupported.
Make sure to support the display assembly when removing these screws.
8. Remove the display assembly.
Figure 5-20. Removing the Display Assembly
Reverse the above procedure to install the display.
Comments to this Manuals