HP 620n User's Guide download pdf (Page 53)

ENWW TCP/IP Configuration 53

TCP/IP Access Control

allow: netnum [mask]

Makes an entry into the host access list stored on the HP Jetdirect print server.

Each entry specifies a host or network of hosts that are allowed to connect to the

printer. The format is “allow: netnum [mask]” where netnum is a network number

or host IP address, and mask is an address mask of bits applied to the network

number and host address to verify access. Up to 10 access list entries are allowed.

If there are no entries, all hosts are permitted access. For example,

allow: 192.0.0.0 255.0.0.0 allows hosts on network 192.

allow: 192.168.1.2 allows a single host. In this case, the default mask

255.255.255.255 is assumed and is not required.

allow: 0 This entry clears the host access list.

For additional information, see Chapter 7

TCP/IP Other Settings

syslog-config:

Enables or disables syslog server operation on the print server: 0 disables,

1 (default) enables.

syslog-svr:

(syslog-srv:)

The syslog server’s IP address. It specifies the server that the HP Jetdirect print

server sends syslog messages to. For more information, see Appendix A

syslog-max:

Specifies the maximum number of syslog messages that can be sent by the

HP Jetdirect print server on a per-minute basis. This setting allows administrators

to control the log file size. The default is 10 per minute. If it’s set to zero, the number

of syslog messages is not restricted.

syslog-priority:

Controls the filtering of syslog messages sent to the syslog server. The filter

range is 0 to 8, with 0 being the most specific and 8 the most general. Only

messages that are lower than the filter level specified (or higher in priority) are

reported. The default is 8, messages of all priorities are sent. If 0, all syslog

messages are disabled.

syslog-facility:

A code used to identify the source facility of a message (for example, to identify

the source of selected messages during troubleshooting). By default, the

HP Jetdirect print server uses LPR as the source facility code, but local user values

of local0 through local7 can be used to isolate individual or groups of print servers.

slp-config:

Enables or disables the Service Location Protocol (SLP) operation on the print

server: 0 disables, 1 (default) enables.

Table 3.3 TFTP Configuration File Parameters (4 of 12)

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 263 264

No comments

HP 620n User's Guide Page 53