HP 620n User's Guide download pdf (Page 206)

ENWW HP Jetdirect Configuration Page 206

PORT SELECT: (Ethernet only) Specifies the port on the HP Jetdirect print

server that has been detected for use:

NONE: The print server is not connected to the network.

RJ-45: The RJ-45 network port is connected.

LAA The Locally Administered Address (LAA) identifies the

user-specified LAN hardware address of a print server,

which may be required by some network administrators.

The default address is the print server’s factory-default LAN

hardware address.

PORT CONFIG: Identifies the link configuration of the RJ-45 port on the

HP Jetdirect 10/100Base-TX print server:

10BASE-T HALF: 10 Mbps, half-duplex

10BASE-T FULL: 10 Mbps, full-duplex

100TX HALF: 100Mbps, half-duplex

100TX-FULL: 100Mbps, full-duplex

UNKNOWN: The print server is in an initialization state.

DISCONNECTED: A network connection has not been

detected. Check network cables.

AUTONEGOTIATION Identifies whether IEEE 802.3u Autonegotiation on the

HP Jetdirect 10/100TX port is enabled (ON) or disabled

(OFF).

ON (default): The HP Jetdirect print server will attempt to

automatically configure itself onto the network at the proper

speed (10 or 100 Mbps) and mode (half or full duplex).

Autonegotiation is enabled after a cold reset.

OFF: You must manually configure the speed and mode

using the EIO menu from the printer’s control panel. If

Autonegotiation is off, the settings must match those of

the network for proper operation.

MANUFACTURING ID: The manufacturing identification code for use by HP online

support personnel.

DATE

MANUFACTURED:

Identifies the date of manufacture of the HP Jetdirect print

server.

Table 9.1 HP Jetdirect Configuration (2 of 2)

Message Description

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 263 264

No comments

HP 620n User's Guide Page 206