HP 620n User's Guide Page 216

  • Download
  • Add to my manuals
  • Print
  • Page
    / 264
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 215
ENWW HP Jetdirect Configuration Page 216
DEFAULT GATEWAY: The IP address of the gateway used when sending packets
off the local network. Only one default gateway may be
configured. During initialization, a temporary value 0.0.0.0
is displayed. If not provided, the IP address of the Jetdirect
print server is used.
NOT SPECIFIED: Indicates that a default gateway is not
configured.
CONFIG BY: Identifies how the HP Jetdirect print server obtained its
IP configuration:
BOOTP: Automatic configuration through a BOOTP server.
BOOTP/TFTP: Automaticautomatic configuration through
a BOOTP server and TFTP configuration file.
DHCP: Automatic configuration through a DHCP server
DHCP/TFTP: Automatic configuration through a DHCP
server and TFTP configuration file.
RARP: Automatic configuration through the Reverse
Address Resolution Protocol.
USER SPECIFIED: Manual configuration through Telnet,
the printer’s control panel, HP Web Jetadmin, embedded
Web server, or other method.
DEFAULT IP: The default IP address was assigned. This
address may not be a valid address for your network.
AUTO IP: A link-local IP address (169.254.x.x) was
assigned. If the network is a link-local network, this address
should be valid.
NOT CONFIGURED: The print server was not configured
with IP parameters. Verify that TCP/IP is enabled, or check
for error status.
BOOTP SERVER:
or
DHCP SERVER:
or
RARP SERVER:
Displayed if BOOTP, DHCP, or RARP is used for TCP/IP
configuration. It specifies the IP address of the system that
responds to the HP Jetdirect print server's request for
automatic TCP/IP configuration over the network.
NOT SPECIFIED: Indicates that the configuration server's
IP address could not be determined or was set to zero in
the response packet.
BOOTP/DHCP
SERVER:
Displayed during initialization while the HP Jetdirect print
server attempts to obtain its TCP/IP configuration from a
BOOTP or DHCP server. The temporary address
displayed is 0.0.0.0.
Table 9.6 TCP/IP Configuration Information (2 of 4)
Message Description
Page view 215
1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 263 264

Comments to this Manuals

No comments