Hardware options installation 38
7. Install the server into the chassis ("Installing the server into the chassis" on page 25).
8. Power up the server (on page 15).
After installing the DIMMs, to configure memory protection mode, use RBSU ("HP ROM-Based Setup Utility"
on page 83).
Drive guidelines
When adding drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one drive is used, install it in the bay with the lowest device number.
• To provide the greatest storage space efficiency when drives are grouped together into the same drive
array, drives must be the same capacity.
Installing a hot-plug drive
1. Remove the drive blank.
2. Prepare the drive.
Comments to this Manuals