Hp ProLiant SL230s Gen8 Server User Manual download pdf (Page 37)

Hardware options installation 37

• Each channel must have a valid online spare configuration.

• Each channel can have a different valid online spare configuration.

• Each populated channel must have a spare rank. A single dual-rank DIMM is not a valid configuration.

Lockstep Memory population guidelines

For Lockstep memory mode configurations, observe the following guidelines:

• Observe the general DIMM slot population guidelines (on page 36).

• DIMM configuration on all channels of a processor must be identical.

• In multi-processor configurations, each processor must have a valid Lockstep Memory configuration.

• In multi-processor configurations, each processor may have a different valid Lockstep Memory

configuration.

Population order

For memory configurations with a single processor or multiple processors, populate the DIMM sequentially in

alphabetical order (A through H).

After installing the DIMMs, use RBSU to configure Advanced ECC, online spare, or lockstep memory support.

Installing a DIMM

CAUTION: To avoid damage to the drives, memory, and other system components, the air

baffle, and drive blanks must be installed when the server is powered up.

1. Power down the server (on page 15).

2. Remove the server from the chassis (on page 15).

3. Remove the processor air baffle (on page 17).

4. Open the DIMM slot latches.

5. Install the DIMM.

6. Install the processor air baffle (on page 18).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 109 110

No comments

Hp ProLiant SL230s Gen8 Server User Manual Page 37