HP OMEN 27 Display User Manual download pdf (Page 18)

Mounting the display head

The display head can be attached to a wall, swing arm, or other mounting xture.

NOTE: This apparatus is intended to be supported by a UL or CSA Listed wall-mount bracket.

IMPORTANT: This VESA mount kit supports the VESA industry-standard 100 mm mounting holes. To attach

a third-party mounting solution to the VESA mount, use four 4 mm, 0.7 pitch, 10 mm–long screws. Longer

screws must not be used because they may damage the monitor. It is important to verify that the

manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the weight of

the monitor display panel. For best performance, it is important to use the power and video cables provided

with the monitor.

Removing the monitor stand

You can remove the display head from the stand to install the display head on a wall, a swing arm, or other

mounting xture.

IMPORTANT: Before beginning to disassemble the monitor, be sure the monitor is turned o and all cables

are disconnected.

1. Disconnect and remove all cables from the monitor.

2. Lay the monitor face down on a at surface covered by a soft clean cloth.

3. Press the release button on the underside of the stand’s hinge (1), and then slide the stand o the

display head (2).

12 Chapter 1 Getting started

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

No comments

HP OMEN 27 Display User Manual Page 18