HP J7949E User Manual Page 204

  • Download
  • Add to my manuals
  • Print
  • Page
    / 232
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 203
ENWW HP Jetdirect Configuration Page 204
5E DHCP LEASE
RELEASED
The lease for DHCP-configured parameters, including the
IP address, have been released through a manual
configuration method, such as through the printer’s control
panel.
5F WINS
REGISTRATION
FAILED
Attempts to register the print server’s name on the WINS
server failed. Check for duplicate names, or verify the WINS
server configuration.
61 AUTO IP
CONFIGURED
An IP address could not be retrieved over the network. The
print server will default to an IP address using link-local
addressing in the form 169.254.x.x.
62 DEFAULT IP
CONFIGURED
An IP address could not be retrieved over the network.
The print server will default to a legacy default IP address
192.0.0.192.
63 AUTO IP IN
PROGRESS
The print server is automatically assigning an IP address
using link-local addressing in the form 169.254.x.x.
64 INVALID
PA S S WORD
An invalid password was specified through TFTP. Verify that
the password consists of a maximum of 16 printable
characters.
83 DISCONNECTING
FROM SERVER
The server has been shut down because of a configuration
change or reset request. This message automatically clears
after a few seconds, unless the printer is offline, is in an error
state, or is servicing another I/O port or another network
protocol.
84 DHCP LEASE
TIMERS ADJUSTED
The print server detected a DHCP lease error due to one of
the following conditions:
Renew time is less than 30 seconds.
Rebind time is less than 52 seconds.
Rebind time is less than, or equal to, the Renew time.
The lease duration is less than, or equal to,
the Rebind time.
F1 TRYING TO
CONNECT TO
SERVER
The HP Jetdirect print server is trying to connect to the
NetWare server(s). This is a normal message. Wait until
either the connection is established or another status
message appears.
F2 TFTP IN
PROGRESS
The print server is attempting to use TFTP to obtain TCP/IP
configuration settings over the network.
F3 BOOTP/RARP IN
PROGRESS
The print server is attempting to use BootP or RARP to
obtain TCP/IP configuration settings over the network.
F4 BOOTP/DHCP IN
PROGRESS
The print server is attempting to use BootP or DHCP to
obtain TCP/IP configuration settings over the network.
Table 9.9 Error Messages (10 of 10)
Error Code and
Message
Description
Page view 203
1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 231 232

Comments to this Manuals

No comments