Hp 2910AL User Manual download pdf (Page 447)

100

101

File Transfers

Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation

Copying Diagnostic Data to a Remote

Host, USB Device, PC or UNIX

Workstation

You can use the CLI to copy the following types of switch data to a text file in

a destination device:

■ Command Output: Sends the output of a switch CLI command as a file on

the destination device.

■ Event Log: Copies the switch’s Event Log into a file on the destination

device.

■ Crash Data: software-specific data useful for determining the reason for

a system crash.

■ Crash Log: Processor-Specific operating data useful for determining the

reason for a system crash.

The destination device and copy method options are as follows (CLI key word

is in bold):

■ Remote Host via TFTP.

■ Physically connected USB flash drive via the switch’s USB port.

■ Serially connected PC or UNIX workstation via Xmodem.

Copying Command Output to a Destination Device

Syntax:

copy command-output < “cli-command” > tftp < ip-address > < filepath-

filename >

copy command-output < “cli-command” > usb < filename >

copy command-output <“cli-command”> xmodem

These commands direct the displayed output of a CLI

command to a remote host, attached USB device, or to a serially

connected PC or UNIX workstation.

For example, to use Xmodem to copy the output of show config to a serially

connected PC:

A-35

1 2 ... 442 443 444 445 446 447 448 449 450 451 452 ... 617 618

Comments to this Manuals

No comments

Hp 2910AL User Manual Page 447

Comments to this Manuals

Related products and manuals for Computer Accessories Hp 2910AL