Hp 2910AL User Manual download pdf (Page 154)

100

101

Interface Access and System Information

Interface Access: Console/Serial Link, Web, and Inbound Telnet

[inactivity-timer < 0 | 1 | 5 | 10 | 15 | 20 | 30 | 60 |120 >]

[events <none | all | non-info | critical | debug]

[local-terminal <vt 100 | none | ansi>]

Note If you change the Baud Rate or Flow Control settings for the switch, you

should make the corresponding changes in your console access device. Other-

wise, you may lose connectivity between the switch and your terminal

emulator due to differences between the terminal and switch settings for these

two parameters.

All console parameter changes except events and inactivity-timer require that

you save the configuration with write memory and then execute boot before the

new console configuration will take effect.

For example, to use one command to configure the switch with the following:

■ VT100 operation

■ 19,200 baud

■ No flow control

■ Critical log events

you would use the following command sequence:

ProCurve(config)# console terminal vt100 baud-rate 19200 flow-control none

events critical

Command will take effect after saving configuration and reboot

ProCurve(config)# write memory

ProCurve(config)# reload

The switch implements the Event Log change immediately. The switch implements

the other console changes after executing

write memory and reload.

Figure 7-4. Example of Executing the Console Command with Multiple Parameters

7-8

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 617 618

Comments to this Manuals

No comments

Hp 2910AL User Manual Page 154

Comments to this Manuals

Related products and manuals for Computer Accessories Hp 2910AL