HP xw9400 User's Guide download pdf (Page 24)

Installing the operating system and software

The following sections discuss operating system and HP software installation procedures.

Microsoft Windows XP Professional

The first time you power on your workstation, you are prompted to select a language for the operating

system. After selecting the language, read and follow the instructions on the screen to complete the

installation of the operating system. This process takes approximately 10 minutes, depending on the

system hardware configuration. During the process, do not power off your workstation unless you are

directed to do so.

Installing or upgrading device drivers

To install hardware devices, such as a printer, a display adapter, or network adapter after the operating

system installation is completed, the operating system needs access to the appropriate software drivers

for the devices. Device drivers are usually provided on a CD supplied with the peripheral device.

Some existing peripheral devices might not have been shipped with drivers developed for Windows XP.

To locate the most current device drivers, see

http://www.hp.com/go/workstationsupport.

Linux-preinstalled workstations

If you have a Linux-preinstalled workstation, follow the instructions in this section to set up your operating

system and software.

After the boot process completes, you can view additional HP Linux documentation by opening your

Internet browser (the browser is automatically set to use the local HP documentation page as its default).

You can also access Linux Web links for Red Hat (Internet access required) by using your Internet

browser.

For additional information about setting up Linux-preinstalled or Linux-enabled workstations, refer to

the HP User Manual for Linux at

http://www.hp.com/support/linux_user_manual.

For more information about HP and Linux, see

http://www.hp.com/linux.

Starting the Linux operating system

The first time your workstation is booted, the Red Hat First Boot utility displays. This program enables

you to enter your password, network, graphics, time, and keyboard settings for your workstation.

CAUTION After the automatic installation has begun, do not power down your workstation until

the process is complete. Powering down your workstation during the installation process might

damage the software that runs your workstation or prevent its proper installation.

When you enable the YPBind feature in the Network tab of the Linux Setup Tool, you might get a blank

screen for about 15–30 seconds after you have selected and saved all of your settings and exited the

utility. This behavior is normal. The boot process continues its execution after the screen returns.

Upgrading device drivers

Once your workstation is up and running, visit http://www.hp.com/go/workstationsupport to see if there

are newer device drivers available for your workstation and/or components.

16 Chapter 2 Installing or restoring the operating system ENWW

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 209 210

No comments

HP xw9400 User's Guide Page 24