Hp Officejet 4400 All-in-One Printer - K410a User Manual download pdf (Page 46)

Cause: You pressed the On button too quickly.

I connected the USB cable, but I am having problems using the HP All-in-One with

my computer

Solution: You must first install the software that came with the product before

connecting the USB cable. During installation, do not plug in the USB cable until

prompted by the onscreen instructions.

Once you have installed the software, connecting your computer to the product with

a USB cable is straightforward. Simply plug one end of the USB cable into the back

of your computer and the other into the back of the product. You can connect to any

USB port on the back of your computer.

If you installed the software, uninstall it and then reinstall it, connecting the USB cable

only when prompted.

For more information on installing the software and connecting the USB cable, see

the Start Here guide that came with the product.

Cause: The USB cable was connected before the software was installed.

Connecting the USB cable before prompted can cause errors.

After setting up the product, it does not print

Try the following solutions to resolve the issue. Solutions are listed in order, with the most

likely solution first. If the first solution does not solve the problem, continue trying the

remaining solutions until the issue is resolved.

•

Solution 1: Press the On button to turn on the product

•

Solution 2: Set your product as the default printer

•

Solution 3: Check the connection between the product and computer

•

Solution 4: Check that the cartridges are installed properly and have ink

•

Solution 5: Load paper in the input tray

Chapter 8

44 Solve a problem

Solve a problem

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 105 106

No comments

Hp Officejet 4400 All-in-One Printer - K410a User Manual Page 46