HP HSR6600 Installation Manual download pdf (Page 32)

T1 cable

You can use an 8T1 interface cable to connect to MIM-8T1/MIM-8T1-F modules.

Figure 29 8T1 splitter cable

CAUTION:

• When connecting the interface cable, pay attention to the mark on the interface to avoid wrong

insertion, which may damage the interface module or even the router.

• HP recommends that you install a lightning protector at the input end of the 8T1 cables to protect them

against lightning strikes more efficiently when they are led outdoors.

Connecting an E1/T1 cable

Connecting an E1 cable (D15/D68 <----> BNC)

CAUTION:

hen connectin

the interface cable, pay attention to the mark on the interface to avoid wron

insertion,

hich may dama

e the interface module or even the router.

• If you do not need to extend the cable, you can directly connect the BNC connectors of the E1

75-ohm cable to the remote network device as follows.

a. Connect the D15/D68 connector of the E1 75-ohm cable to the D15/D68 interface of the

interface module and fasten the bolts to fix the cable.

b. The other end of the cable provides one pair or multiple pairs of 75-ohm BNC connectors.

Connect the TX connectors and the RX connectors on this end to the RX connectors and the TX

connectors on the remote device respectively.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 106 107

No comments

HP HSR6600 Installation Manual Page 32