HP HSR6600 Installation Manual download pdf (Page 60)

Displaying the operational status of power modules

Use the display power command to display the operational status of power modules.

<Sysname> display power

Power 1 State: Absent

Power 2 State: Normal

Table 17 Output description

Field Descri

tion

Power Number of the power supply

State

The power supply state:

• Normal—The power supply is operating properly.

• Absent—The power supply is not in position.

• Fault—The power supply fails.

Displaying the alarming thresholds of a module

When the router is operating, too high a temperature and too low a temperature of a module affect the

normal operation of the router. When the temperature of a module exceeds 53°C (127.4°F) or drops

below –10°C (14°F), the system sends traps to prompt you to solve the problem.

To display the alarming thresholds of a module:

Ste

Command

Remarks

1. Enter system view

system-view N/A

2. (Optional) Display the temperature information

of your router

display environment Available in any view

Configuring a combo interface

Combo interface overview

A combo interface is a logical interface comprising an SFP port of a transceiver module and an RJ-45

Ethernet port. The two ports share one forwarding interface, so they cannot work simultaneously. When

you enable either port, the other port is automatically disabled. You can select to activate a port as

needed.

Configuration prerequisites

Use the display interface interface-type interface-number command to find out which port is an SFP port

and which port is an RJ-45 Ethernet port.

• If the output includes “Media type is not sure, Port hardware type is No connector”, it means that the

port is an SFP port. For example, the following output shows that GigabitEthernet 0/0/2 is an SFP

port.

[Sysname] display interface GigabitEthernet 0/0/2

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 106 107

No comments

HP HSR6600 Installation Manual Page 60