HP HSR6600 Installation Manual download pdf (Page 48)

Replacing a FIP module

CAUTION:

hen the RUN LED of the FIP module is fast flashin

, do not unplu

the FIP module.

To replace a FIP module, for example, FIP-20:

1. Determine the FIP module to be removed. This section takes the FIP module in slot 3 as an example.

2. Use a Philips screwdriver to loosen the captive screws of the FIP module to be removed until all

spring pressure is released.

3. Holding the ejector levers of the FIP module with both hands, pull the ejector levers outward, and

gently pull the FIP module out of the slot along the slide rails.

Figure 53 Pulling the FIP module out of the slot

4. If you do not install a new FIP module in the slot, install a blank panel. To install a new FIP module,

see “Installing a FIP module.”

NOTE:

To replace a FIP module when the router is running, perform the remove slot

slot-number

command and

then unplug the module.

Replacing a HIM/MIM

NOTE:

To replace a HIM/MIM module when the router is running, perform the remove slot

slot-number

command and then unplug the module.

The procedures for replacing HIMs and MIMs are similar. This example replaces a MIM to a FIP-20.

To replace a MIM:

1. Determine the MIM to be removed. Use a flat-blade screwdriver to completely loosen the captive

screws of the MIM to be removed.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 106 107

No comments

HP HSR6600 Installation Manual Page 48