HP 2500C Series User Manual download pdf (Page 151)

Removal and Replacement of Parts (without Calibration) 7-1

Chapter 7 Removal and Replacement of Parts (without

Calibration)

This chapter describes how the printer can be disassembled for repair and maintenance. This section covers

the removal of parts that can be reassembled without calibration. To reassemble the printer, reverse the order

of the procedure. Where required, additional explanation will also be provided for any special adjustments or

procedure steps (such as instances where reassembly differs from disassembly).

You should also take note that it may not be necessary to disassemble the printer to service certain

components.

Removal and Replacement Tools

To disassemble the printer, you will need the following tools :

1. A TORX



screwdriver with T-10 and T-20 screw bits.

2. Needle nose pliers.

3. Straight tweezers.

4. A flat-blade screw driver (Philips no.1 or flathead no.5).

5. Instruction manual.

It is strongly recommended that proper tools (including screws) be used for the job.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 224 225

No comments

HP 2500C Series User Manual Page 151